Hidra Scorp

 ¿Name? 

Its name is HidraScor because it’s a scorpion and its motor functions are making whit water

Implements:

1.     32 Needles Of. 60cc

2.     120 pallets the one that doctor use in consult

3.     100 screws about approximate to 3.4cm of long distance

4.     16 intravenous tube

5.     Tape or in case that there’s no one use an plastic secure

1-. In First place it has to star to assemble the feet’s of the scorpion, being 3 on each side there are 6 in total, on a way that it could move perpendicularly whit the needles that must be on between the pallets, with the screws doing pressure to hold them to a prudential distance without making them create an incredible pressure on the needles. Check out our illustration down make by the group:

2-. Once we end the first step, its important to put some  sticky tape, and make sure that the legs cant move from the place, in it's absence  some plastic holders instead, unite the screws whit the palets.

3-. The last step must be repeated 3 times to be united to the 3 legs on each side, one finish that step, must be assemble the superior part of the torso, where is going to be the Pliers of the HidraScor, This superior part or the torso is going to intercalate leaving space between the pallets, for the other part of the torso.

 

4-. The last step to end our HidraScor is doing the tail of our scorpion, to make this happen, we got to make a long extension of pallets that connect whit needles on a way that make’s move our tail when the water 

came into the needle. Check the 

image down:

Remenber theres no impossible, theres only new missions to be make 

This is the finish experiment